The Flow Max RV Fresh Water Pump # LC689052 would be a great choice to replace what you have. It has similar gallons per minute, amperage draw, and psi so it would be a really great choice. view full answer...
I had our warehouse measure the RV Hand Pump Water Faucet # 37297025 you referenced and from the bottom of the of the chrome mounting plate to the highest part of the unit is 6".
I included a diagram of this measurement for you to take a look at. view full answer...
I attached a picture that shows the mounting hole dimensions of the Flow Max RV Fresh Water Pump part # LC689052 that you referenced to compare to what you have now. This mounting pattern is a standard size so it should fit what you have but you'd want to check to make sure!
I attached a review video for this pump for you to check out as well. view full answer...
I went out to the warehouse to measured the HydroMax RV Fresh Water Pump # P25201 and found that is measures 8-1/4" long x 5-1/4" tall x 10-1/4" wide. view full answer...
I was able to get the distance between the mounting holes for you of the RV Hand Pump Water Faucet # 37297025.
As you can see by the accompanying diagram, the holes are 3-1/8 inches apart.
In regards to the mounting hardware, you will only need to use two of the screws in order to install the Water Faucet # 37297025. view full answer...
The pressure rating the Camco RV Drinking Water Hose # CAM22743 is 40-70 psi so it would easily handle the pressure of city water or RV water pumps which are normally only rated for up to 45 psi. This is 10 foot in length. view full answer...
Sounds like you are curious about the dimensions of the Valterra RV Water Tank # R8030 so you can determine if this will fit. This measures 30" x 8" x 16" and can carry up to 15 gallons. view full answer...
I contacted the vendor and the Valterra RV Water Tank - Non-Toxic - ABS Plastic - 24" x 8" x 16" - 12 Gallons # R8024 does not have any specific pressure rating since it is designed to be gravity fed or used with low-pressure water pumps.
The dimensions are 24" long, 8" wide, and 16" tall (see attached photo). As long as your space is larger than theses dimensions, it will fit. I attached a short demonstration video for you. view full answer...
I went out into our warehouse and measured the fittings of the part # CAM36543 that you referenced and found that the inner diameter of the T-fitting is right at 1/2 inch whereas the outer diameter of the fitting is 3/4 of an inch. view full answer...
The Furrion Tankless water heater part # FR48SR that you referenced requires a minimum water pressure of .32 gallons per minute. Which if you need a water pump installed on your setup the Flow Max part # LC689052 would be a really great option. view full answer...
The FloTool Multipurpose Transfer Pump # FT10803 is a small pump to get a vacuum started and let gravity assist to siphon the fluid, so it is not rated with any pressure, or flow rate. The amount of time it takes depends on the volume of water your trying to transfer. view full answer...
I reached out to Derale, who as able to confirm for me that the pilot inner diameter was 5/8 inches of the Derale Thermal Fan Clutch with Reverse Rotation # D22140. view full answer...
The seal that is part of the mechanism in Repair Kit # RP320 has a 1.53 inch outer diameter. It can't be easily removed from the mechanism though. I have included a picture with other measurements for other parts in this kit as well. view full answer...
I went out to our warehouse for you and measured the Prest-O-Fit Adapter for RV Sewer Hose part # PR66FR, the inner diameter of hose side is right at 2-3/4".
I can't confirm fit with the FloJet Macerator Pump unfortunately as this is no something we offer. view full answer...
I can definitely help you replace the AC units on your Duo Therm model # 630035.321 system. However, none of the units we currently offer come with heat pumps. To replace just the rooftop units you'll want the Furrion Chill HE Replacement RV Air Conditioner for Coleman Setup item # FR42PV. This is going to plug into the wiring you have now and would allow you to keep your current thermostat to control it.
If you're needing to replace the entire system, I recommend the Furrion Chill HE... view full answer...
Yes, most 12 volt accessory circuits that 7-ways have are rated for 40 amps so a 7.5 amp draw would not be an issue at all.
I attached a help article with trailer wiring diagrams for you to check out as well. view full answer...
If your 2007 Winnebago Voyage has the Kwikee Level Best Hydraulic RV Leveling System then you will need the Replacement Lippert Touchpad for Kwikee Level Best Hydraulic Leveling System item # LC68UD. This is the correct replacement touchpad for Kwikee Level Best Systems with the auto-level control function for your Winnebago Voyager.
We don't have any parts to replace the pump system or hydraulic motor but I would start by checking the reservoir and the lines. If these check out you may... view full answer...
I went out to the warehouse and measured the total depth of the shroud for the Derale # D16925 at 1-1/2".
To use this as a puller fan you would reverse polarity and would need to use a custom shroud, as the included fan has to many openings to be effective as a puller. view full answer...